Moisture Testing

By Lenny Hall, Endurance Floor Company

Many wood flooring contractors believe that if they are conducting repairs on an existing wood floor, and that existing wood floor has been performing well for several years, there is no need to test for moisture.Ā They would be wrong.

Case in point.Ā I recently had a job to repair and extend an existing wood floor that had been installed in 1999.Ā The flooring in question was a select grade 2Ā¼ā€ red oak installed over a diagonal subfloor, which was nailed on 15# asphalt paper.Ā The floor was finished with three coats of moisture-cured natural gloss polyurethane.Ā The house had a ventilated crawl space, and the floor has remained flat since it was originally installed.

As I do on every job, we tested the existing floor, the subfloor, and the new flooring materials for moisture.Ā Those readings revealed some surprises.

The subfloor tested at an average 13.77% MC.Ā The original floor tested at an average 11.63%.Ā The new flooring material tested at an average of 6.6%.

img_1566img_1576img_1577

NWFA guidelines state not to install unless the moisture content difference between the wood floor and the subfloor is less than 4% for 2Ā¼ā€ material (guidelines for material wider than 3ā€ require a difference of no more than 2%).

It is understandable that the new wood would differ from the existing wood, but it is not easy to explain the difference between the existing wood and the subfloor.Ā  Especially since the two materials were functioning at equilibrium moisture content as evidenced by the many years of stability.

The explanation has to do with how moisture meters work.Ā  Measured electrical resistance converted to a value as determined by an algorithm may not display the same value across variable species even when set to the proper species on the same meter.
On our job, this meant that the new floor needed to be acclimated to the original floor readings to be in EMC with the subfloor.Ā This meant that we had to raise the MC of the new wood by 5%.

Here is where some ingenuity comes into play.Ā  To accomplish this, we laid out plastic on the floor, opened bundles, and spread out the repair wood plus our 10 control pieces.

img_5753img_5755

We wet them heavily on the tops, sides, and bottoms.Ā  We then covered this wood with another sheet of plastic and sealed it to the first layer of plastic to keep the moisture we added from evaporating.Ā  This allowed the wood to absorb moisture.

Two days later, our test control samples were 8.4%.Ā  We repeated the process, and three days later, the control samples measured 10.78%, meaning we could install the new material.

img_1586

Itā€™s important to remember that even on flooring jobs that donā€™t appear to have moisture issues, testing before installation and repairs can save you many headaches down the road.

2 thoughts

Leave a Reply

Your email address will not be published.